Witchy Ghost Heat Transfer – Halloween Iron-On DIY

Witchy Ghost with Broom – Heat Transfer (Approx. Size: 3.5in x 3.5in)

Add some magical fun to your Halloween crafts with this adorable witchy ghost design! 👻✨ This sweet little ghost is dressed in a purple witch hat with a star charm, holding a broom and a pumpkin bucket ready for trick-or-treating. A perfect mix of spooky and cute to brighten up any DIY project.

• Design: Ghost in witch hat with broom & pumpkin bucket 🎃🧹

• Approx. Size: 3.5in x 3.5in

• Application: Heat press recommended for best results

• Perfect For: T-shirts, hoodies, trick-or-treat bags, tote bags, and Halloween gifts

A charming choice for Halloween fans who love whimsical and playful designs

HOW TO APPLY:

Home-Iron:

1 Protect surface your ironing on with a heat mat or towel etc

2 Place your t-shirt or fabric into place and iron for 5 seconds to remove creases

3 Place your DTF Image Transfer into position

4 Turn off your steam function, empty water from iron. Set Iron to Cotton 130-150°C

5 Iron with firm pressure for 10-15 seconds

6 Wait until the transfer is cool and slowly peel off the clear film

7 If the transfer is not fully adhered then please repeat step 5 - Make sure you re-place the clear film.

Heat Press:

1 Heat press at 160c (Celsius) for 30 seconds.

2 Allow to cool for 90 seconds.

3 Peel the DTF PET film to reveal the transfer.

4 Apply a DTF finishing sheet over the transfer.

5 Heat press again at 160c (Celsius) for 10 seconds to finish.